Description
0.6ohm Mesh Coil for the Voopoo PnP Range
The PnP-VM4 is a 0.6ohm mesh coil rated at 20-28W. It sits between the MTL coils and the full sub-ohm builds – a restricted direct-to-lung draw rather than either extreme.
0.6ohm at around 25W is the most versatile setting on any PnP kit. It is warm enough to carry a fruit or dessert properly, loose enough to inhale straight to the lung, and still economical on liquid. If you are unsure which PnP coil to start with, it is this one.
🔌 Voopoo PnP VM4 Coils
✔ 0.6ohm mesh at 20-28W
✔ Restricted direct-to-lung draw
✔ Mesh for even heating
✔ The most versatile coil in the PnP range
What It Fits
Made for the Voopoo PnP platform, which spans a lot of kits: Vinci, Vinci R, Vinci X and Vinci Air, Drag S and Drag X, Drag Max, Navi, Argus GT and Argus Air, and the PnP 20 and 22 pods.
Will not fit: TPP coils, despite also being Voopoo. The two platforms use different fittings and are not interchangeable.
Specification
- Resistance: 0.6ohm
- Wattage: 20-28W
- Type: mesh
- Draw: restricted direct-to-lung
What It Is Built For
This resistance is made for restricted direct-to-lung vaping — a draw between a cigarette pull and a full sub-ohm inhale. Suits 50/50 liquids and lower-strength shortfills equally.
When To Change It
Mid-power mesh gives a fair run, typically a week or two. Sweeter liquids shorten it more here than on the 1.0ohm and 1.2ohm coils because there is more heat going through the wick.
Getting the Most From a Coil
Keep the strength sensible – a 20mg nic salt at 0.6ohm and 28W is far more nicotine than most people want. A 10mg salt or a low-strength shortfill suits it much better.
You May Also Like
Frequently Asked Questions
What wattage for the VM4?
20-28W.
Is it MTL or DTL?
Restricted direct-to-lung – between the two.
Which nicotine strength?
10mg salt or a low-strength shortfill. 20mg would be harsh at this resistance.
Is it mesh?
Yes.
Reviews
There are no reviews yet.