GTIN: 6958947123754 SKU: N/A Categories: , Tags: , , , Brand:

Aspire Breeze Coils – 5 Pack

£8.99

Aspire Breeze coils, 5 per pack: 0.6 ohm SS316L (Breeze and Breeze 2), 1.0 ohm (Breeze 2, Aspire’s pick for nic salts) and 1.2 ohm Kanthal (Breeze). Not for the Breeze NXT.

Description

Aspire Breeze Coils: 0.6, 1.0 and 1.2 Ohm for the Breeze and Breeze 2

Aspire Breeze coils are the replacement coils for Aspire’s Breeze and Breeze 2 pod kits, five to a pack. We list three resistances, and which one you need depends on which Breeze you have.

The 0.6Ω is identical in both generations, so it fits either. The 1.2Ω is the original Breeze coil and the 1.0Ω is the Breeze 2 coil: Aspire says they share a structure and will swap, but it doesn’t recommend doing it, so match the coil to your kit.

🔌 Aspire Breeze Coils at a Glance

✔ Five coils per pack
✔ 0.6Ω SS316L: Breeze and Breeze 2
✔ 1.0Ω: Breeze 2
✔ 1.2Ω Kanthal: Breeze
✔ Aspire’s pick for nic salts: the 1.0Ω
✔ Not for the Breeze NXT

Breeze Coils by Kit

From Aspire’s Breeze coil page and its Breeze and Breeze 2 FAQ. The Breeze fires at a fixed output, so there’s no wattage to set, and Aspire doesn’t publish one for these coils.

Resistance Wire (Aspire) Made for Will it swap?
0.6Ω SS316L stainless steel Breeze and Breeze 2 Yes: Aspire says it is exactly the same coil in both
1.0Ω Not stated Breeze 2 Fits the Breeze, but Aspire advises against it
1.2Ω Kanthal Breeze Fits the Breeze 2, but Aspire advises against it
White Vape Co recommends: on a Breeze 2 with nic salts, use the 1.0Ω: it’s the coil Aspire recommends for nicotine salt. On an original Breeze, the 1.2Ω gives the tighter draw. The 0.6Ω suits either kit if you’d like a looser pull and more vapour with a lower-strength liquid.

Which Devices Take Aspire Breeze Coils?

Aspire lists the 0.6Ω for the Breeze and Breeze 2, the 1.2Ω for the Breeze, and the 1.0Ω for the Breeze 2.

The Aspire Breeze 2 replacement pod we stock takes Breeze 2 coils, so both the 0.6Ω and the 1.0Ω on this page fit it. Aspire says the 0.6Ω is exactly the same coil in both generations, so a pack of 0.6Ω coils covers an original Breeze too.

Will not fit: the Breeze NXT – Aspire makes a separate 0.8Ω mesh coil for it.

How to Change a Breeze Coil

  1. Take the pod out of the device. On the Breeze 2, squeeze the release buttons on each side.
  2. Remove the used coil.
  3. Wet the new coil’s cotton through its side holes, and add a drop to the top.
  4. Fit the new coil and refill. On the Breeze 2, turn the pod over, lift the silicone seal, fill through the hole and press the seal back firmly.
  5. Leave it for about five minutes before you vape.

How Long Does a Breeze Coil Last?

Aspire doesn’t publish a coil life. The Breeze runs at a fixed output, so what wears the coil is mostly the liquid: sweet, dark flavours and chain vaping shorten it. Change it when the flavour dulls or turns burnt.

Breeze Coil Troubleshooting

Problem Likely cause and fix
Burnt taste from a new coil It wasn’t primed, or wasn’t given long enough. Prime the next one and wait.
Poor performance after swapping generations The 1.0Ω and 1.2Ω will swap between the Breeze and Breeze 2, but Aspire advises against it. Use the coil made for your kit.
Leaking The coil isn’t seated fully, or the silicone seal isn’t pressed back firmly.
Too harsh on the 0.6Ω Drop your nicotine strength, or switch to the 1.0Ω or 1.2Ω.

Best E-Liquids for Breeze Coils

With the 1.0Ω or 1.2Ω, use nic salts at 10mg or 20mg, or a 50/50 freebase e-liquid at 12mg to 18mg. With the 0.6Ω, go lower: a 50/50 freebase at 3mg to 6mg.

Buy Aspire Breeze Coils Near You

Need Aspire Breeze coils today? Our Totton vape shop, Hythe vape shop and Holbury vape shop stock Aspire coils, tanks and pods, and the team can check which resistance suits your device and e-liquid. Tell us whether you have the Breeze or the Breeze 2 and we’ll hand you the right coil. Stock varies by store, so give us a call before you travel. Ordering online instead? See our delivery options.

You May Also Like

Frequently Asked Questions

Are Breeze and Breeze 2 coils the same?

The 0.6Ω is identical in both. The Breeze 1.2Ω and the Breeze 2 1.0Ω share a structure and will swap, but Aspire doesn’t recommend it.

Which Breeze coil is best for nic salts?

On the Breeze 2, the 1.0Ω, which Aspire recommends for nicotine salt.

Do Breeze coils fit the Breeze NXT?

No. The Breeze NXT uses its own 0.8Ω mesh coil.

How many coils are in a pack?

Five.

Does the 0.6 Breeze coil fit the Breeze 2 pod?

Yes. Aspire says the 0.6Ω is exactly the same coil in both generations.

Additional information

Weight 0.068 kg
ohm

0.6ohms, 1.2ohms, 1.0ohms

Coil Ohm

0.6 Ohm, 1 Ohm, 1.2 Ohm

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…