GTIN: 2388206003062 Categories: , Tags: , , Brand:

Horizontech Falcon F1 Coils – 3 Pack

£13.49

HorizonTech Falcon F1 coils: 0.2Ω, rated 80W, with a 70% cotton and 30% wood pulp wick. Fits the Falcon, Falcon King and Falcon Legend tanks (not the Falcon II). Three per pack.

In stock

Description

Falcon F1 Coils: HorizonTech 0.2 Ohm, 80W

Falcon F1 coils are HorizonTech’s 0.2Ω heads for its Falcon tank family, rated at 80W. Each pack holds three.

The F1 uses a nichrome coil and a wick of 70% cotton and 30% wood pulp. HorizonTech says the microporous blend lets e-liquid soak through more evenly, and its chart shows the flavour holding steady from the first puff.

HorizonTech Falcon F1 coil with its 70% cotton and 30% wood pulp wick
The F1 and its 70% cotton, 30% wood pulp wick.

🔌 HorizonTech Falcon F1 Coils

✔ Three coils per pack
✔ 0.2Ω nichrome coil
✔ Rated 80W (70–90W)
✔ 70% cotton and 30% wood pulp wick
✔ Fits the Falcon, Falcon King and Falcon Legend tanks

Falcon F1 vs F2, F3 and the M-Series

HorizonTech’s Falcon Legend page lists ten coils for the tank family. Here are the three F-series heads, plus the two M-series coils we also stock:

Coil Resistance Rated power
F1 (this pack) 0.2Ω 80W
F2 0.2Ω 80W
F3 0.2Ω 70W
M1 0.15Ω 70–80W
M-Triple 0.15Ω 80–85W
White Vape Co recommends: run the F1 at 80W, HorizonTech’s own figure, and treat 70–90W as the working band. If the tank gets hot or the flavour sharpens, drop 5W.
HorizonTech Falcon F3, F2 and F1 coil heads
F3, F2 and F1: the three F-series heads.

Which Tanks Do Falcon F1 Coils Fit?

The F1 fits the original HorizonTech Falcon, the Falcon King and the Falcon Legend.

We sell two of them. The HorizonTech Falcon King Tank is the upgraded Falcon, with a push-button lid that pops open for filling, and HorizonTech says it takes all Falcon coils. The newer HorizonTech Falcon Legend Tank adds bottom-to-top airflow and its own M8 and M6 coils, and HorizonTech lists it as compatible with every Falcon M and F series coil, the F1 included.

Want to try mesh in either tank? Our Falcon M1 coils and Falcon M-Triple coils fit both as well.

Will not fit: the Falcon II. Despite the name, it uses its own Sector Mesh coils, so F1 heads won’t fit.

Falcon coils compatible with the HorizonTech Falcon Legend tank, F1 0.2 ohm 80W among them
HorizonTech’s Falcon Legend coil list, with the F1 on the bottom row.

How to Fit and Prime Falcon F1 Coils

  1. Empty the tank and unscrew the base from the glass section.
  2. Remove the used F1 and wipe the base clean.
  3. Wet the new coil’s cotton through its side holes. HorizonTech prints its own advice on the box: soak a new coil for 10 minutes for decent flavour.
  4. Fit the coil, reassemble the tank and fill.
  5. After the ten-minute soak, start a little under 80W and take a few short puffs.

How Long Does a Falcon F1 Coil Last?

It’s one of the most-asked Falcon questions, and HorizonTech doesn’t answer it with a number. At 80W, a daily vaper typically gets one to two weeks. The wood pulp in the wick helps resist the burnt edge that finishes cotton coils early, but very sweet liquids still coat the coil quickly.

Falcon F1 Troubleshooting

Problem Likely cause and fix
Burnt taste on the first puff It missed HorizonTech’s ten-minute soak. Prime the next one properly.
Flavour thin and hot The power is above 90W. Bring it back to 80W.
The coil won’t fit your tank Check it isn’t a Falcon II, which uses Sector Mesh coils rather than the F series.

Best E-Liquids for Falcon F1 Coils

An 80W coil wants high-VG liquid. Choose 70/30 or 80/20 shortfill e-liquids and add a nic shot for about 3mg. Leave nic salts and stronger 10ml e-liquids for low-wattage MTL kits.

Buy Falcon F1 Coils Near You

Need Falcon F1 coils today? Our Totton vape shop, Hythe vape shop and Holbury vape shop stock HorizonTech coils and tanks, and the team can check the coil is right for your tank. Bring your Falcon in if you’re not sure whether it’s a King, a Legend or a Falcon II. Stock varies by store, so give us a call before you travel. Ordering online instead? See our delivery options.

You May Also Like

Frequently Asked Questions

Do F1 coils fit the Falcon King?

Yes. HorizonTech says the Falcon King takes all Falcon coils.

Do F1 coils fit the Falcon Legend?

Yes. The F1 is on HorizonTech’s Falcon Legend compatibility list.

What wattage is the Falcon F1?

HorizonTech rates it at 80W; 70–90W is the usable band.

Do Falcon F1 coils fit the Falcon II?

No. The Falcon II takes its own Sector Mesh coils.

How long do Falcon King coils last?

HorizonTech gives no figure. At 80W, a daily vaper usually gets one to two weeks from an F1.

Specifications

Weight 0.068 kg
Coil Ohm

0.2 Ohm

Coil Wattage

80-100w

Reviews are from customers who bought the product from us. Vape Club members receive loyalty points for leaving a review, whether it is positive or negative. We do not remove reviews for being negative.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…