Description
OXVA NeXlim Unitech 3.0 Pods for Every NeXlim
The OXVA NeXlim Unitech 3.0 pod is OXVA’s latest NeXlim cartridge, and the one to buy for any NeXlim. It fits the NeXlim 2, NeXlim 2 Mini, NeXlim GO and the original NeXlim, and comes three to a pack in 0.6Ω, 0.8Ω and 1.2Ω.
Unitech 3.0 is OXVA’s third-generation dual mesh design. OXVA quotes up to 200% more flavour and 200% longer life than single-mesh pods, priming in about 30 seconds instead of a few minutes, a much larger condensate chamber to stop spitting, and triple anti-leak protection. In practice, it is ready sooner, stays cleaner and lasts longer.
🔌 OXVA NeXlim Unitech 3.0 Pods
✔ Three pods per pack
✔ Unitech 3.0 dual mesh coil
✔ Fits NeXlim, NeXlim GO, NeXlim 2 and NeXlim 2 Mini
✔ Primes in about 30 seconds
✔ Larger condensate chamber and triple anti-leak design
✔ Separate wattage bands for Boost and Eco
Unitech 3.0 Wattage: Boost vs Eco
Every NeXlim has Boost and Eco modes, and OXVA gives each Unitech 3.0 resistance its own wattage band for each mode. The device sets the power for you; this is what it is aiming for:
| Resistance | Boost | Eco | Draw |
|---|---|---|---|
| 0.6Ω | 36–40W | 20–25W | RDL |
| 0.8Ω | 28–32W | 14–18W | RDL or MTL |
| 1.2Ω | 20–25W | 10–13W | MTL |
Which NeXlim Devices Do Unitech 3.0 Pods Fit?
OXVA lists the Unitech 3.0 cartridge for every NeXlim model, and we stock all four.
The OXVA NeXlim 2 Pod Kit is the flagship partner for these pods: up to 40W, Boost and Eco modes and three-level airflow, so every Unitech 3.0 resistance gets its full Boost wattage. The OXVA NeXlim 2 Mini Pod Kit packs the same pod into a smaller 1500mAh body with double-tap Boost and Eco switching and up to 30W, which makes the 0.8Ω the natural choice on Boost. The OXVA NeXlim GO Pod Vape Kit switches between Boost and Eco with a slider and runs from an 1800mAh battery, and the original OXVA NeXlim Pod Vape Kit takes Unitech 3.0 pods as a straight upgrade on its first-generation cartridges.
Unitech 3.0 pods do not fit any XLIM. If you are not sure which NeXlim you have, our NeXlim vs NeXlim GO guide and NeXlim 2 and NeXlim 2 Mini review show the differences.
Will not fit: any XLIM device. XLIM and NeXlim pods are not interchangeable – for an XLIM, choose XLIM V3 replacement pods or XLIM EZ pods.
How to Fill and Prime a Unitech 3.0 Pod
- Take the pod out of your NeXlim.
- Open the top-fill plug and fill slowly, leaving a little space at the top.
- Close the plug fully and wipe the contacts.
- Refit the pod and wait about 30 seconds – the Unitech 3.0 wick soaks far faster than older pods.
- Take the first few puffs in Eco, then switch to Boost if you want it (on the 0.8Ω or 1.2Ω).
How Long Does a Pod Last?
OXVA rates a Unitech 3.0 pod at roughly 80ml of e-liquid on Boost and up to around 120ml in Eco. That is a long life for a pod, and it is why the mode you use matters more than the resistance. If a pod is falling well short of those figures, the usual causes are a 0.6Ω on Boost, very sweet e-liquid, or chain vaping without giving the wick time to recover.
Unitech 3.0 Pod Problems and Fixes
| Problem | Likely cause and fix |
|---|---|
| 0.6Ω pod burning out fast | It is being run on Boost. Use the 0.8Ω for Boost, or keep the 0.6Ω in Eco. |
| Leaking | The top plug is not fully closed, or the pod was filled to the brim. Close it firmly and leave a gap. |
| Spitting | Rare with the larger condensate chamber, but a hard draw on a fresh pod can do it. Flick the pod into a tissue and take gentler draws. |
| Burnt taste on first puff | Fired before the 30-second soak, or started on Boost. Give the next one a moment and begin in Eco. |
| No pod detected | Clean the contacts and reseat the pod. Make sure it is a NeXlim device – these do not fit any XLIM. |
Unitech 3.0 vs Original NeXlim Pods
| NeXlim pod | NeXlim Unitech 3.0 pod | |
|---|---|---|
| Coil | Dual mesh | Unitech 3.0 dual mesh |
| Made for | The original NeXlim kit | NeXlim, NeXlim GO, NeXlim 2 and NeXlim 2 Mini |
| Ready to vape | Let it soak for a few minutes | About 30 seconds |
| Spit and condensation control | Five-layer leak-proof design | Larger condensate chamber and triple anti-leak |
| Resistances | 0.6, 0.8, 1.2Ω | 0.6, 0.8, 1.2Ω |
The original NeXlim replacement pods are still a good match for the first NeXlim kit, but the Unitech 3.0 is the one that covers every model.
Best E-Liquids for These Pods
Unitech 3.0 pods suit nic salts and 50/50 freebase. OXVA’s own Ox Passion nic salts are made to partner the NeXlim, and our 10ml e-liquids cover freebase. On Boost, a lower strength goes further – many customers drop from 20mg to 10mg salts when they move to the 0.8Ω on Boost. For the full picture on the kits, read our NeXlim 2 and NeXlim 2 Mini review.
Buy NeXlim Unitech 3.0 Pods Near You
Need Unitech 3.0 pods today? Our Totton vape shop, Hythe vape shop and Holbury vape shop stock OXVA pods and kits, and the team can check which resistance suits your device and e-liquid. We can check your NeXlim model and help you choose between the 0.6Ω and 0.8Ω. Stock varies by store, so give us a call before you travel. Ordering online instead? See our delivery options.
You May Also Like
- OXVA NeXlim Replacement Pods
- OXVA NeXlim 2 Pod Kit
- OXVA NeXlim 2 Mini Pod Kit
- NeXlim 2 and NeXlim 2 Mini Review
- Ox Passion Nic Salts
- All Replacement Vape Pods
Frequently Asked Questions
Are these the newest NeXlim pods?
Yes. Unitech 3.0 is OXVA’s current NeXlim cartridge.
Do Unitech 3.0 pods fit the NeXlim 2 Mini?
Yes. They fit the NeXlim 2 Mini, NeXlim 2, NeXlim GO and the original NeXlim.
Which Unitech 3.0 resistance should I use on Boost?
The 0.8Ω. On Boost the 0.6Ω runs at 36–40W and burns out quickly. Use the 0.6Ω in Eco with nic salts for the best flavour.
How long does a Unitech 3.0 pod last?
Around 80ml of e-liquid on Boost and up to 120ml in Eco, by OXVA’s figures.
Will Unitech 3.0 pods fit an XLIM?
No. NeXlim pods only fit NeXlim devices.
Do I replace the coil separately?
No. The dual mesh coil is built into the pod – you replace the whole pod.
Are XLIM pods compatible with NeXlim?
No. XLIM pods do not fit NeXlim devices, and NeXlim pods do not fit XLIMs.
What wattage does the NeXlim 0.8 ohm pod run at?
On the Unitech 3.0, 28–32W on Boost and 14–18W in Eco.
Reviews
There are no reviews yet.