Voopoo TPP DM1 Coils – 3 Pack

0.15ohm Mesh Coil for the Voopoo TPP Range

The DM1 is the 0.15ohm mesh coil in the TPP range, rated 60-80W. It is the general-purpose sub-ohm option: enough power for a warm, full draw without the wattage demands of the DM3.

DM1 and DM3 share the same 0.15ohm resistance but are built for very different wattage windows, which is the part people most often get wrong. If your kit tops out below 80W, DM1 is the one you want.

What It Fits

Made for the Voopoo TPP platform: the TPP Pod and TPP Pod Tank, TPP Pod 2, TPP X Pod, and the MAAT Tank. On kits, that covers the Drag 3, Drag X Plus, Drag X Pro, Drag S Pro and the Argus MT, XT and GT II.

Will not fit: PnP coils and TPP coils are not interchangeable despite both being Voopoo – check which platform your kit uses before ordering.

Specification

• Resistance: 0.15ohm
• Wattage: 60-80W
• Pack size: 3 coils
• Type: mesh
• Draw: direct-to-lung

What It Is Built For

This resistance is made for sub-ohm direct-to-lung vaping — a warm, airy draw and plenty of vapour. Use a shortfill at 70/30 or higher. High-strength nic salts are not suitable at this resistance.

When To Change It

At 60-80W a mesh coil of this size typically gives one to two weeks. Sweetened liquids will cut that sharply – a dessert shortfill can halve it.

Getting the Most From a Coil

Prime before the first fill and give it five minutes standing. TPP coils run at real power, so a dry wick burns almost immediately – and once it has, no amount of resting will bring it back.

You May Also Like

• Voopoo TPP DM3 Coils
• Voopoo TPP DM4 Coils
• Shortfill e-liquids

Frequently Asked Questions

What wattage does the DM1 run at?

60-80W.

How is it different from the DM3?

Same 0.15ohm resistance, but the DM3 is built for 80-100W. DM1 is the better match for most kits.

How many in a pack?

Three.

Can I use nic salts?

No. At 0.15ohm use a shortfill – a high-strength salt would be overwhelming.