Aspire Flexus AF Mesh Coils

0.6ohm and 1.0ohm Mesh Coils for the Aspire Flexus

The AF mesh coil for the Aspire Flexus pod range, in 0.6ohm and 1.0ohm. Mesh rather than round wire, which heats more evenly and gives a cleaner flavour from the first pull.

Two resistances covers two quite different vapes from the same kit: 1.0ohm for a tight cigarette-like draw on nic salts, 0.6ohm for something looser and warmer on a lower strength. It is worth having both in the drawer rather than settling on one.

What It Fits

Made for the Aspire Flexus pod starter kit and the Flexus range.

Specification

• Resistances: 0.6ohm and 1.0ohm
• Type: mesh
• Fits: Aspire Flexus pod kits
• Best with: nic salts at 1.0ohm, 50/50 or low-strength shortfill at 0.6ohm

What It Is Built For

This resistance is made for restricted direct-to-lung vaping — a draw between a cigarette pull and a full sub-ohm inhale. Suits 50/50 liquids and lower-strength shortfills equally.

When To Change It

Mesh gives plenty of warning – flavour dulls gradually rather than failing suddenly. A week or two is normal, less on sweet liquids.

Getting the Most From a Coil

Match the resistance to the nicotine: 1.0ohm with a 10mg or 20mg salt, 0.6ohm with something weaker. A 20mg salt through a 0.6ohm coil is harsh rather than harmful, but you will not enjoy it.

You May Also Like

• Replacement vape coils
• Nic salts for pod kits
• 10ml e-liquids

Frequently Asked Questions

Which resistance should I pick?

1.0ohm for nic salts and a tight draw, 0.6ohm for a looser vape on a lower strength.

Are these mesh?

Yes, both.

Will they fit other Aspire kits?

They are made for the Flexus range specifically.

Can I use a shortfill?

At 0.6ohm yes. At 1.0ohm a 50/50 or salt wicks better.